Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 32 of 509
Mod. 0808 2011-07 Rev.2
4.1.3. Hayes Compliant AT Commands
4.1.3.1. Generic Modem Control
Set To Factory-Defined Configuration - &F
&F - Set To Factory-Defined Configuration
Execution command sets the configuration parameters to default values specified by
manufacturer; it takes in consideration hardware configuration switches and other
manufacturer-defined criteria.
Parameter:
<value>:
0 - just the factory profile base section parameters are considered.
1 - either the factory profile base section and the extended section are considered
(full factory profile).
Note: if parameter <value> is omitted, the command has the same behaviour as
Soft Reset - Z
Execution command loads the base section of the specified user profile and the
extended section of the default factory profile.
Parameter:
<n>
0..1 - user profile number
Note: any call in progress will be terminated.
Note: if parameter <n> is omitted, the command has the same behaviour as ATZ0.
To Next Page
Loading...
Need help?
General
