Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 429 of 509
Mod. 0808 2011-07 Rev.2
4.1.6.13. SIM Toolkit Commands
SIM Tookit Interface Activation - #STIA
#STIA - SIM Toolkit Interface Activation
[<mode>
[,<timeout>]]
Set command is used to activate the SAT sending of unsolicited indications when a
proactive command is received from SIM.
Parameters:
<mode>
0 - disable SAT
1 - enable SAT without unsolicited indication #STN (default)
2 - enable SAT and extended unsolicited indication #STN (see #STGI)
3 - enable SAT and reduced unsolicited indication #STN (see #STGI)
17 - enable SAT without unsolicited indication #STN and 3GPP TS 23.038
alphabet used
18 - enable SAT and extended unsolicited indication #STN (see #STGI) and 3GPP
TS 23.038 alphabet used
19 - enable SAT and reduced unsolicited indication #STN (see #STGI)and 3GPP
TS 23.038 alphabet used
33 - enable SAT without unsolicited indication #STN and UCS2 alphabet used
34 - enable SAT and extended unsolicited indication #STN (see #STGI)and UCS2
alphabet used
35 - enable SAT and reduced unsolicited indication #STN (see #STGI)and UCS2
alphabet used
<timeout> - time-out for user responses
1.. 2 - time-out in minutes (default 2). Any ongoing (but unanswered) proactive
command will be aborted automatically after <timeout> minutes. In this
case, the terminal response is either “ME currently unable to process
command”, or if applicable, “No response from user”. In addition an
unsolicited indication will be sent to the external application:
#STN: <cmdTerminateValue>
where:
<cmdTerminateValue> is defined as <cmdType> + terminate offset;
the terminate offset equals 100.
Note: every time the SIM application issues a proactive command that requires
user interaction an unsolicited code will be sent, if enabled with #STIA command,
as follows:
To Next Page
Loading...
Need help?
General
