Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 301 of 509
Mod. 0808 2011-07 Rev.2
TCP AT Run in dial (client) mode - #TCPATRUND
#TCPATRUND – Enables TCP Run AT Service in dial (client) mode
Set command enables/disables the
TCP AT RUN service in client mode. When this service is enabled, the
module tries to open a connection to the Host (the Host is specified in
AT#TCPATRUNCFG).
Parameter:
< mod >
0: Service Disabled
1: Service Enabled
Note1: If SMSATRUN is active on the same instance (see
AT#TCPATRUNCFG) the command will return ERROR.
Note2: when the service is active it is on a specific AT instance (see
AT#TCPATRUNCFG), that instance cannot be used for any other scope.
For example if the multiplexer request to establish the Instance, the
request will be rejected.
Note3: the current setting are stored in NVM
Note4: to start automatically the service when the module is powered-on,
the automatic PDP context activation has to be set (see AT#SGACTCFG
command).
Note5:
if the connection closes or at boot, if service is enabled and context
is active, the module will try to reconnect for the number of attempts
specified in AT#TCPATRUNCFG; also the delay between one attempt
and the other will be the one specified in AT#TCPATRUNCFG.
Read command returns the current settings of <mode> and the value of
<stat> in the format:
#TCPATRUND: <mod>,<stat>
where:
<stat> - connection status
0 - not connected
1 – connected or connecting at socket level
2 - not connected but still trying to connect, attempting every delay
time (specified in AT#TCPATRUNCFG)
Test command returns the supported values for the TCPATRUND
parameters
To Next Page
Loading...
Need help?
General
