Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 113 of 509
Mod. 0808 2011-07 Rev.2
Time Zone reporting - +CTZR
+CTZR – Time Zone reporting
This command enables and disables the time zone change event reporting.
If the reporting is enabled the MT returns
the unsolicited result code +CTZV: <tz> whenever the time zone is
changed.
Parameters:
<onoff>:
0 Disable time zone change event reporting (default)
1 Enable time zone change event reporting
Read command reports the currently selected <onoff> in the format:
+CTZR: <onoff>
Test command reports the supported range of values for parameter
<onoff>
Automatic Time Zone update - +CTZU
+CTZU – automatic Time Zone update
This command enables and disables automatic time zone update via NITZ.
Parameters:
<onoff>:
0 Disable automatic time zone update via NITZ (default)
1 Enable automatic time zone update via NITZ
Note: despite of the name, the command AT+CTZU=1 enables automatic
update of the date and time set by AT+CCLK command (not only time
zone). This happens when a Network Identity and Time Zone (NITZ)
message is sent by the network. This command is the ETSI standard
equivalent of Telit custom command AT#NITZ=1. If command
AT+CTZU=1, or AT#NITZ=1 (or both) has been issued, NITZ message
will cause a date and time update.
Read command reports the currently selected <onoff> in the format:
+CTZU: <onoff>
Test command reports the supported range of values for parameter
<onoff>
To Next Page
Loading...
Need help?
General
