Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 125 of 509
Mod. 0808 2011-07 Rev.2
4.1.4.5. Mobile Equipment Errors
Report Mobile Equipment Error - +CMEE
+CMEE - Report Mobile Equipment Error
Set command enables/disables the report of result code:
+CME ERROR: <err>
as an indication of an error relating to the +Cxxx commands issued.
When enabled, device related errors cause the +CME ERROR: <err> final result
code instead of the default ERROR final result code. ERROR is anyway returned
normally when the error message is related to syntax, invalid parameters, or DTE
functionality.
Parameter:
<n> - enable flag
0 - disable +CME ERROR:<err> reports, use only ERROR report.
1 - enable +CME ERROR:<err> reports, with <err> in numeric format
2 - enable +CME ERROR: <err> reports, with <err> in verbose format
Read command returns the current value of subparameter <n>:
Test command returns the range of values for subparameter <n>
+CMEE has no effect on the final result code +CMS
To Next Page
Loading...
Need help?
General
