Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 160 of 509
Mod. 0808 2011-07 Rev.2
Select Cell Broadcast - +CSCB
+CSCB -Select Cell Broadcast Message Types
[<mode>[,<mids>
[,<dcss>]]]
Set command selects which types of Cell Broadcast Messages are to be received by
the device.
Parameters:
<mode>
0 - the message types defined by <mids> and <dcss> are accepted (factory
default)
1 - the message types defined by <mids> and <dcss> are rejected
<mids> -
Message Identifiers, string type: all different possible combinations of the
CBM message identifiers; default is empty string (“”).
<dcss> - Data Coding Schemes, string type: all different possible combinations of
CBM data coding schemes; default is empty string (“”).
Note: the current settings are stored through +CSAS
Read command reports the current value of parameters <mode>, <mids> and
<dcss>.
Test command returns the range of values for parameter <mode>.
+CSCB: 1,"",""
OK (all CBMs are accepted, none is rejected)
AT+CSCB=0,"0,1,300-315,450","0-3"
3GPP TS 27.005, 3GPP TS 23.041, 3GPP TS 23.038.
To Next Page
Loading...
Need help?
General
