Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 298 of 509
Mod. 0808 2011-07 Rev.2
TCP Run AT Service in listen (server) mode - #TCPATRUNL
#TCPATRUNL– Enables TCP AT Run Service in listen (server) mode
<mod>
Set command enables/disables the TCP AT RUN service in server mode. When
this service is enabled, the module tries to put itself in TCP listen state.
Parameter:
< mod >
0: Service Disabled
1: Service Enabled
Note1: If SMSATRUN is active on the same instance (see
AT#TCPATRUNCFG) the command will return ERROR.
Note2: when the service is active it is on a specific AT instance (see
AT#TCPATRUNCFG), that instance cannot be used for any other scope. For
example, if the multiplexer requests to establish the Instance, the request will
be rejected.
Note3: the current settings are stored in NVM.
Note4: to start automatically the service when the module is powered-on, the
automatic PDP context activation has to be set (see AT#SGACTCFG
command).
Read command returns the current settings of <mode> and the value of <stat>
in the format:
#TCPATRUNL: <mod>,<stat>
where:
<stat> - connection status
0 – not in listen
1 - in listen or active
Test command returns the supported values for the TCPATRUNL parameters
To Next Page
Loading...
Need help?
General
