Telit Wireless Solutions LE910 - Carrier off with Firm Time - S10; Command Line Editing Character - S5; Connection Completion Time-Out - S7; Escaper Prompt Delay - S12

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 55 of 509
Mod. 0808 2011-07 Rev.2
Command Line Editing Character - S5
S5 - Command Line Editing Character
SELINT 2
ATS5=[<char>]
Set command sets the value of the character recognized by the device as a request
to delete from the command line the immediately preceding character.
Parameter:
<char> - command line editing character (decimal ASCII)
0..127 - factory default value is 8 (ASCII BS)
ATS5?
Read command returns the current value of S5 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
Reference
V25ter
Connection Completion Time-Out - S7
S7 - Connection Completion Time-Out
SELINT 2
ATS7=[<tout>]
Set command sets the amount of time, in seconds, that the device shall allow
between either answering a call (automatically or by A command) or completion of
signalling of call addressing information to network (dialing), and establishment of
a connection with the remote device.
Parameter:
<tout> - number of seconds
1..255 - factory default value is 60
ATS7?
Read command returns the current value of S7 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
Reference
V25ter
– Carrier Off With Firm Time - S10
S10 –Carrier Off With Firm Time
SELINT 2
ATS10
Execution command has no effect and is included only for backward compatibility
with landline modems
– Escaper Prompt Delay - S12
S12 - Escape Prompt Delay
SELINT 2
ATS12=[<time>]
Set command sets:
1)
the minimum period, before receipt of the first character of the three escape
character sequence, during which no other character has to be detected in
order to accept it as valid first character;
2) the maximum period allowed between receipt of first or second character of
the three escape character sequence and receipt of the next;