To Next Page

To Previous Page

Telit LE910 V2 Series AT Commands

80446ST10707A Rev. 0– 2015-11-03

Mod. 0808 2011-07 Rev.2

<action_id>

Identifier of the action to trigger when the threshold limit has been

reached. It corresponds to the AT command associated to the event

CONSUMEX, where X=1,…5. (Refer to #EVMONI command)

Range: (0-5); 0 means no action associated: in this case only the counter is

active.

Note: the Set command #CONSUMECFG=0 has a special behaviour: for

all the enabled rules, the data and time of related counters are reset (if they

are not-life counters)

Note: the values set by command are directly stored in NVM and don’t

depend on the specific AT instance

Note: the life counters are disabled if <enable> parameter of

AT#ENACONSUME is equal to 0

Note: a rule can be changed only setting <rule_enable>=0. The data and

time of related counter are also reset (if it’s not a life counter).

Note: when the period expires, the counted data are reset, so the counting

in the next period starts from 0.

Note: if a service is blocked, then the related (life or not) counter is

stopped also in terms of time (as well as in terms of data obviously).

AT#CONSUMECFG?

Read command returns the current settings for each rule in the format:

#CONSUMECFG:

<rule_id>,<service_type>,<rule_enable>,<period>,<limit_amount>,<a

ction_id>

AT#CONSUMECFG=?

Test command reports the supported range of values for all parameters

Enable consume funztionality - #ENACONSUME

#ENACONSUME – enable consume functionality

SELINT 2

AT#ENACONSUME=<enable

>[,<storing_mode>[,<storing_

period>]]

Set command enables/disables the consume functionality.

Parameters:

0 – disable consume functionality (default)

1 – disable consume functionality except life counters

2 – enable consume functionality

Telit Wireless Solutions LE910 User Manual

Questions and Answers: