Telit Wireless Solutions LE910 - Show Text Mode Parameters - +CSDH

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 159 of 509
Mod. 0808 2011-07 Rev.2
+CSMP - Set Text Mode Parameters
SELINT 2
Example
Set the parameters for an outgoing message with 24 hours of validity period and
default properties:
AT+CSMP=17,167,0,0
OK
Set the parameters for an outgoing message with validity period in enhanced
format: the <vp> string actually codes 24 hours of validity period.
AT+CSMP=9,“01A80000000000“
OK
Set the parameters for an outgoing message with validity period in enhanced
format: the <vp> string actually codes 60 seconds of validity period.
AT+CSMP=9,“023C0000000000“
OK
Set the parameters for an outgoing message with validity period in enhanced
format: the <vp> string actually codes 29 hours 85 minutes 30 seconds of validity
period.
AT+CSMP=9,“03925803000000“
OK
Reference
3GPP TS 27.005; 3GPP TS 23.040; 3GPP TS 23.038
Show Text Mode Parameters - +CSDH
+CSDH - Show Text Mode Parameters
SELINT 2
AT+CSDH=
[<show>]
Set command controls whether detailed header information is shown in text mode
(AT+CMGF=1) result codes.
Parameter:
<show>
0 - do not show header values defined in commands +CSCA and +CSMP (<sca>,
<tosca>, <fo>, <vp>, <pid> and <dcs>) nor <length>, <toda> or <tooa> in
+CMT, +CMGL, +CMGR result codes for SMS-DELIVERs and SMS-
SUBMITs in text mode. For SMS-COMMANDs in +CMGR result code do not
show <pid>, <mn>, <da>, <toda>, <length> or <cdata>
1 - show the values in result codes
AT+CSDH?
Read command reports the current setting in the format:
+CSDH: <show>
AT+CSDH=?
Test command reports the supported range of values for parameter <show>
Reference
3GPP TS 27.005