Telit Wireless Solutions LE910 - Network Service Handling; Read Operator Names - +COPN; Subscriber Number - +CNUM

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 68 of 509
Mod. 0808 2011-07 Rev.2
+CSTA – Select Type of Address
SELINT 2
AT+CSTA=?
Test command reports the range for the parameter <type>
4.1.4.3. Network Service Handling
Subscriber Number - +CNUM
+CNUM - Subscriber Number
SELINT 2
AT+CNUM
Execution command returns the MSISDN (if the phone number of the device has
been stored in the SIM card) in the format:
+CNUM: <alpha>,<number>,<type>[<CR><LF>
+CNUM: <alpha>,<number>,<type>[…]]
where:
<alpha> - alphanumeric string associated to <number>; used character set should
be the one selected with +CSCS.
<number> - string containing the phone number in the format <type>
<type> - type of number:
129 - national numbering scheme
145 - international numbering scheme (contains the character "+").
AT+CNUM=?
Test command returns the OK result code
Reference
3GPP TS 27.007
Read Operator Names - +COPN
+COPN - Read Operator Names
SELINT 2
AT+COPN
Execution command returns the list of operator names from the ME in the format:
+COPN: <numeric1>,<alpha1>[<CR><LF>
+COPN: <numeric2>,<alpha2>[…]]
where:
<numericn> - string type, operator in numeric format (see +COPS)
<alphan> - string type, operator in long alphanumeric format (see +COPS)
Note: each operator code <numericn> that has an alphanumeric equivalent
<alphan> in the ME memory is returned
AT+COPN=?
Test command returns the OK result code
Reference
3GPP TS 27.007