Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 56 of 509
Mod. 0808 2011-07 Rev.2
S12 - Escape Prompt Delay
3) the minimum period, after receipt of the last character of the three escape
character sequence, during which no other character has to be detected in
order to accept the escape sequence as a valid one.
Parameter:
<time> - expressed in fiftieth of a second
2..255 - factory default value is 50.
Note: the minimum period S12 has to pass after CONNECT result code
too, before a received character is accepted as valid first character of the
three escape character sequence.
Read command returns the current value of S12 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
Delay To DTR Off - S25
Set command defines the amount of time, in hundredths of second, that the device
will ignore the DTR for taking the action specified by command &D.
Parameter:
<time> - expressed in hundredths of a second
0..255 - factory default value is 5.
Note: the delay is effective only if its value is greater than 5.
Note: command not yet implemented
Note: in power saving (e.g. CFUN 5 with DTR low) DTR has to be off at least 3
seconds for taking the action specified by command &D, independently of S25
Read command returns the current value of S25 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
To Next Page
Loading...
Need help?
General
