Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 404 of 509
Mod. 0808 2011-07 Rev.2
#GDATAVOL - GPRS Data Volume
<receivedn> - number of bytes received, in every GPRS (or GSM) session
since last reset, for <cidn> PDP context;
Note: last GPRS and GSM session counters are not saved in NVM so they are
loosen at power off.
Note: total GPRS and GSM session counters are saved on NVM.
Test command returns the range of supported values for parameter <mode>.
ICMP Ping Support - #ICMP
#ICMP - ICMP Ping Support
Set command enables/disables the ICMP Ping support.
Parameter:
<mode>
0 - disable ICMP Ping support (default)
1 - enable firewalled ICMP Ping support: the module is sending a proper
ECHO_REPLY only to a subset of IP Addresses pinging it; this subset of IP
Addresses has been previously specified through #FRWL (see)
2 - enable free ICMP Ping support; the module is sending a proper
ECHO_REPLY to every IP Address pinging it.
Read command returns whether the ICMP Ping support is currently enabled or
not, in the format:
#ICMP: <mode>
Test command reports the supported range of values for the <mode> parameter.
To Next Page
Loading...
Need help?
General
