Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 219 of 509
Mod. 0808 2011-07 Rev.2
OK
Execution command reports UMTS-related information for serving cell and active
cell
at#moni
#MONI: I TIM PSC:65535 RSCP:255 LAC:EF8D Id:52D2388 EcIo:255 UARFCN:65535
PWR:0dbm DRX:128 SCR:0
#MONI: PSC:49 RSCP:-96 EcIo:-2.0 UARFCN:10638 SCR:784
OK
Set command selects the special request to obtain GSM-related information from
the whole set of seven cells in the neighbour list of the serving cell
at#moni=7
OK
Execution command reports the requested information in table-like format
at#moni
#MONI: Cell BSIC LAC CellId ARFCN Power C1 C2 TA RxQual PLMN
#MONI: S 70 55FA 1D23 736 -83dbm 19 33 1 0 I WIND
#MONI: N1 75 55FA 1297 983 -78dbm 26 20
#MONI: N2 72 55FA 1289 976 -82dbm 22 16
#MONI: N3 70 55FA 1D15 749 -92dbm 10 18
#MONI: N4 72 55FA 1D0D 751 -92dbm 10 18
#MONI: N5 75 55FA 1296 978 -95dbm 9 3
#MONI: N6 70 55FA 1D77 756 -99dbm 3 11
The timing advance value is meaningful only during calls or GPRS transfers active.
The serving cell is the current serving cell or the last available serving cell, if the
module loses coverage.
Compressed Cell Monitor - #MONIZIP
#MONIZIP – Compressed Cell Monitor
[<number>]]
#MONIZIP is both a set and an execution command.
Set command sets one cell out of seven, in a the neighbour list of the serving cell
including it, from which extract GSM/UMTS-related information.
Parameter:
<number>
To Next Page
Loading...
Need help?
General
