Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 240 of 509
Mod. 0808 2011-07 Rev.2
AT#PLMNUPDATE=?
Test command returns the range of <action> parameter and the
maximum length of
<MCC>
,
<MNC>
and
<PLMNname>
parameters.
PLMN List Selection - #PLMNMODE
#PLMNMODE – PLMN List Selection
SELINT 2
AT#PLMNMODE=
[<mode>]
Set command selects the list of PLMN names to be used currently
Parameter:
<mode>
1 – disable PLMN list updates set with
#PLMNUPDATE
command
(factory default)
2 – enable PLMN list updates set with
#PLMNUPDATE
command.
Note: <mode> parameter is saved in NVM
AT#PLMNMODE?
Read command reports whether the currently used list of PLMN
names is fixed or not, in the format:
#PLMNMODE: <mode>
(
<mode>
described above)
AT#PLMNMODE=?
Test command returns the supported range of values for
parameter <mode>.
Periodical FPLMN cleaning - #FPLMN
#FPLMN – Periodically FPLMN clearing
SELINT 2
AT#FPLMN=<action>[,<perio
d>]
Periodically delete the Forbidden PLMN list stored inside the SIM card.
Parameters:
<action> :
0 – disable periodic FPLMN clearing (default)
1 – enable periodic FPLMN clearing with period <period>
2 – clear FPLMN file on SIM (one shot)
3 – list contents of forbidden PLMN list file
<period>
: interval in minutes from FPLMN clearing, range 1...60, default
value is 60
Note: the disable/enable value set by command is directly stored in NVM.
AT#FPLMN?
Read command reports whether the periodic deletion is currently enabled
or not,

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English