Telit Wireless Solutions LE910 - Packet Service Network Type - #PSNT

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 242 of 509
Mod. 0808 2011-07 Rev.2
#SCI – Show Call Information
SELINT 2
#SCI:
<index1>,<number>,<text>,<callTime>,<callDuration>[,<status>]<C
R><LF>
#SCI:
<index2>,<number>,<text>,<callTime>,<callDuration>[,<status>][
…]]]
where:
<indexn> - the type of the entry ( 1: incoming call; 2: outgoing call)
<number> - string type phone number
<text> - the alphanumeric text associated to the number; used character
set should be the one selected with command +CSCS
<callTime> - call time yy/MM/dd,hh:mm:ss±zz, where
yy - year
MM - month
dd - day
hh - hour
mm - minute
ss - seconds
±zz - time zone
<callDuration> - call duration in the format: "hh:mm:ss", where
hh - hour
mm - minute
ss - seconds
<status> - only for incoming calls, call status (0: answered: 1: not
answered)
AT#SCI=?
Test command returns the OK result code.
Packet Service Network Type - #PSNT
#PSNT – Packet Service Network Type
SELINT 2
AT#PSNT=[<mode>]
Set command enables/disables unsolicited result code for packet service
network type (PSNT).
Parameter:
<mode>
0 - disable PSNT unsolicited result code (factory default)
1 - enable PSNT unsolicited result code
2 - PSNT unsolicited result code enabled; read command reports
HSUPA and HSDPA related info
AT#PSNT?
Read command reports the <mode>,<nt> and HSUPA and HSDPA
related info in the format: