Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 310 of 509
Mod. 0808 2011-07 Rev.2
Read command reports the status blocked/unblocked of every type of
service in the following format:
#BLOCKCONSUME: <service_type>,<block>
Test command reports the supported range of values for <service_type>
and <block> parameters
#SGACT/#SSENDLINE configuration - #IPCONSUMECFG
#IPCONSUMECFG – #SGACT/#SSENDLINE configuration
[<connId>
[,<txProt>
[,<remoteHost>
[,<remotePort>
[,<authIMEI/ICCIDEna>
[,<unused_A>
[,<unused_B>
[,<unused_C>
]]]]]]]]
This command configures #SGACT authentication and #SSENDLINE
connection parameters.
Parameters:
Following settings take effect on successive #SSENDLINE
command:
<connId>: - socket connection identifier
1(default)..6
Note: verify <connId> is currently available(i.e: not already connected)
by multisocket commands(#SD,#SL,…) before entering successive
#SSENDLINE command
<txProt> - transmission protocol
0 – TCP(default)
1 – UDP
<remoteHost> - address of the remote host, string type.
This parameter can be either:
- any valid IP address in the format: “xxx.xxx.xxx.xxx”
- any host name to be solved with a DNS query.
Default “”
<remotePort> - remote host port to contact
1..65535
Default 1024
Following setting takes effect on successive #SGACT command:
<authIMEI/ICCIDEna> - enables PDP context activation
(#SGACT) authentication(user/pwd) with ICCID/IMEI