Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 273 of 509
Mod. 0808 2011-07 Rev.2
Note: after successful password change (<Mode> 2) password will be not
inserted.
Note: if current password is different from the empty string “” and
password is not inserted then AT commands that make use of the file
system (SCRIPT, M2M, MMS) will have either
ERROR
or
+CME ERROR: 16
or
+CME ERROR: incorrect password
response depending on AT+CMEE setting.
Test command reports the supported range of values for parameters.
First time: change default password
AT#FILEPWD=2,"","mynewpwd"
OK
and insert password
AT#FILEPWD=1,"mynewpwd"
OK
At next power on: insert password
AT#FILEPWD=1,"mynewpwd"
User Determined User Busy - #UDUB
#UDUB – User Determined User Busy
Execution command disconnects all active calls (like ATH or AT+CHUP), but
setting the “user busy” cause for disconnection (only if we have an incoming call
that has not been answered yet, and that we want to reject).
Test command returns the OK result code
To Next Page
Loading...
Need help?
General
