Telit Wireless Solutions LE910 - Read Current Network Status - #RFSTS

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 226 of 509
Mod. 0808 2011-07 Rev.2
Read current network status - #RFSTS
#RFSTS – Read current network status
SELINT 2
AT#RFSTS
Execution command reads current network status, in the format:
(GSM network)
#RFSTS:<PLMN>,<ARFCN>,<RSSI>,<LAC>,<RAC>,<TXPWR>,<MM>,
<RR>,<NOM>,<CID>,<IMSI>,<NetNameAsc>,<SD>,<ABND>
Where:
<PLMN> - Country code and operator code(MCC, MNC)
<ARFCN> - GSM Assigned Radio Channel
<RSSI> - Received Signal Strength Indication
<LAC> - Localization Area Code
<RAC> - Routing Area Code
<TXPWR> - Tx Power
<MM> - Mobility Management state (for debug purpose only)
0 - NULL
3 - LOCATION UPDATING INITIATED
5 - WAIT FOR OUTGOING MM CONNECTION
6 - CONNECTION ACTIVE
7 - IMSI DETACH INITIATED
8 - PROCESS CM SERVICE PROMPT
9 - WAIT FOR NETWORK COMMAND
10 - LOCATION UPDATE REJECTED
13 - WAIT FOR RR CONNECTION LOCATION UPDATE
14 - WAIT FOR RR CONNECTION MM
15 - WAIT FOR RR CONNECTION IMSI DETACH
17 - WAIT FOR REESTABLISHMENT
18 - WAIT FOR RR ACTIVE
19 - IDLE
20 - WAIT FOR ADDITIONAL OUTGOING MM CONNECTION
21 - CONNECTION ACTIVE GROUP TRANSMIT
22 - WAIT RR CONNECTION GROUP TRANSMIT
23 - LOCATION UPDATING PENDING
24 –IMSI DETACH PENDING
25 - RR CONNECTION RELEASE NOT ALLOWED
255 - UNKNOWN
<RR> - Radio Resource state (for debug purpose only)
2 - CELL SELECTION
3 - WAIT CELL SELECTION
4 - DEACTIVATION CELL SELECTION
5 - SELECT ANY CELL
6 - WAIT SELECT ANY CELL
7 - DEACTIVATION SELECT ANY CELL
8 - WAIT INACTIVE