Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 286 of 509
Mod. 0808 2011-07 Rev.2
#CSURV - Network Survey
SELINT 2
GPRS parameters like
<pbcch>
are printed only if GPRS is supported in the
cell but their value is not available and will be always 0.
Parameters like
<mstxpwr>
are printed only for #CSURVEXT=3 setting but
their value is not available and will be always 0.
In 3G
<s>,<e>
fixed couples and the corresponding band, if supported by the
product:
10562,10838 UMTS BAND I
9662,9938 UMTS BAND II
1537,1738 UMTS BAND IV
4357,4458 UMTS BAND V
4387,4413 UMTS BAND VI
2937,3088 UMTS BAND VIII
712,763 UMTS BAND XIX
0,65535 all supported UMTS bands
Network Survey (Numeric Format) - #CSURVC
#CSURVC - Network Survey (Numeric Format)
SELINT 2
AT#CSURVC[=
[<s>,<e>]]
Execution command allows to perform a quick survey through band
channels, starting from channel
<s>
to channel
<e>
. Issuing
AT#CSURVC<CR>
, a full band scan is performed.
Parameters:
<s>
- starting channel
<e>
- ending channel
After issuing the command the device responds with the string:
Network survey started…
and, after a while, a list of informations, one for each received carrier, is
reported, each of them in the format:
In 2G
(For BCCH-Carrier)
<arfcn>,<bsic>,<rxLev>,<ber>,<mcc>,<mnc>,<lac>,<cellId>,

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English