Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 21 of 509
Mod. 0808 2011-07 Rev.2
the same command line, because if one of them fails, then an error message is received but it is
not possible to argue which one of them has failed the execution.
If command V1 is enabled (verbose responses codes) and all commands in a command line has
been performed successfully, result code <CR><LF>OK<CR><LF> is sent from the TA to the
TE, if subparameter values of a command are not accepted by the TA or command itself is invalid,
or command cannot be performed for some reason, result code <CR><LF>ERROR<CR><LF>
is sent and no subsequent commands in the command line are processed.
If command V0 is enabled (numeric responses codes), and all commands in a command line has
been performed successfully, result code 0<CR> is sent from the TA to the TE, if sub-parameter
values of a command are not accepted by the TA or command itself is invalid, or command cannot
be performed for some reason, result code 4<CR> and no subsequent commands in the command
line are processed.
In case of errors depending on ME operation, ERROR (or 4) response may be replaced by +CME
ERROR: <err> or +CMS ERROR: <err>.
NOTE:
The command line buffer accepts a maximum of 400 characters. If this number is exceeded none
of the commands will be executed and TA returns ERROR.
3.2.2.1. ME Error Result Code - +CME ERROR: <err>
This is NOT a command, it is the error response to +Cxxx 3GPP TS 27.007 commands.
Syntax: +CME ERROR: <err>
Parameter: <err> - error code can be either numeric or verbose (see +CMEE).The
possible values of <err> are reported in the table:
phone-adaptor link reserved
To Next Page
Loading...
Need help?
General
