Telit Wireless Solutions LE910 - List Current Calls - +CLCC

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 87 of 509
Mod. 0808 2011-07 Rev.2
+CAOC - Advice Of Charge
SELINT 2
Note
+CAOC command returns an estimate of the cost of the current call only, produced
by the MS and based on the information provided by either AoCI or AOCC
supplementary services; it is not stored in the SIM.
List Current Calls - +CLCC
+CLCC - List Current Calls
SELINT 2
AT+CLCC
Execution command returns the list of current calls and their characteristics in the
format:
[+CLCC:<id1>,<dir>,<stat>,<mode>,<mpty>,<number>,<type>
,<alpha>[<CR><LF>+CLCC:<id2>,<dir>,<stat>,<mode>,
<mpty>,<number>,<type>,<alpha>[…]]]
where:
<idn> - call identification number
<dir> - call direction
0 - mobile originated call
1 - mobile terminated call
<stat> - state of the call
0 - active
1 - held
2 - dialing (MO call)
3 - alerting (MO call)
4 - incoming (MT call)
5 - waiting (MT call)
<mode> - call type
0 - voice
1 - data
9 - unknown
<mpty> - multiparty call flag
0 - call is not one of multiparty (conference) call parties
1 - call is one of multiparty (conference) call parties
<number> - string type phone number in format specified by <type>
<type> - type of phone number octet in integer format
129 - national numbering scheme
145 - international numbering scheme (contains the character " + ")
<alpha> - string type; alphanumeric representation of <number> corresponding to
the entry found in phonebook; used character set should be the one
selected with +CSCS.
Note: If no call is active then only OK message is sent. This command is useful in
conjunction with command +CHLD to know the various call status for call holding.
AT+CLCC=?
Test command returns the OK result code