Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 498 of 509
Mod. 0808 2011-07 Rev.2
#SWMBOOTSTRAP – Configure Bootstrap
Test command reports the supported range of values for all the parameters.
Enable/Disable Self Registration - #SWMREG
#SWMREG –Enable/Disable Self Registration
Set command enables/disables in the SWM Client the self-registration
functionality to an SWM Center service domain. In case self-registration is
enabled, the SWM client will use the domainName and PIN combination to
register upon first OMA-DM session to the correct customer domain
(account) in the SWM Center server.
Parameters:
<mode>
0 – disable (default)
1 – enable
<domainName> - String parameter indicating the SWM Center domain
name to register to. If absent, then a predefined default one is used from the
DM tree configuration.
<PIN> - String parameter indicating the PIN code for registration into the
domain. If absent, then a predefined default one is used from the DM tree
configuration.
Note: after a successful self-registration, any later attempt will not have any
effect.
Note: the self-registration failure is notified with the following URC:
#SWMRING: 1[, <notificationDescription>]
Note: the self-registration is possible only if SWM has previously been
enabled by issuing AT#SWMENA=1 command.
Read command reports the current setting of <mode> parameter in the
format:
#SWMREG: <mode>
The registration credentials are not reported for security reasons.
Test command reports the supported range of values for the <mode>
parameter and the maximum length of <domainName> and <PIN>
parameters in the format:
To Next Page
Loading...
Need help?
General
