Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 142 of 509
Mod. 0808 2011-07 Rev.2
+CGEQOS - parameter command syntax
[<CR>>LF>+CGEQOS: <cid>, <QCI>,
The test command returns the ranges of the supported parameters.
+CGEQOS: (range of supported <cid>s) ,(list of
supported <QCI>s) ,(list of supported <DL_GBR>s),
(list of supported <UL_GBR>s), (list of supported <DL_MBR>s) ,(list of
Parameter command syntax - +CGEQOSRDP
+CGEQOSRDP - parameter command syntax
id>]
+CGEQOSRDP: <cid>, <QCI>,
[<CR>>LF>+CGEQOSRDP: <cid>, <QCI>,
[…]]
Description:
The execution command returns the Quality of Service parameters <QCI>,
[<DL_GBR> and <UL_GBR>] and
[<DL_MBR> and <UL_MBR>]of the established PDP Context associated to the
provided context identifier <cid>. If the context cannot be found an ERROR
response is returned.
If the parameter <cid> is omitted, the Quality of Service parameters for all
established PDP contexts are returned.
Defined values:
<cid>: a numeric parameter which specifies a particular Traffic Flows definition
in EPS and a PDP Context definition in UMTS/GPRS.
<QCI>: a numeric parameter that specifies a class of EPS QoS. (see 3GPP TS
23.203 [85])0 QCI is selected by network [1 – 4] value range for guranteed bit
rate Traffic Flows [5 – 9] value range for non-guarenteed bit rate Traffic Flows.
<DL_GBR>: a numeric parameter, which indicates DL GBR in case of GBR
QCI. The value is in kbit/s. This
parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
<UL_GBR>: a numeric parameter which indicates UL GBR in case of GBR
QCI. The value is in kbit/s. This
parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
To Next Page
Loading...
