Telit Wireless Solutions LE910 - International Mobile Subscriber Identity (IMSI) - #CIMI; Service Provider Name - #SPN; Extended Numeric Error Report - #CEER

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 192 of 509
Mod. 0808 2011-07 Rev.2
International Mobile Subscriber Identity (IMSI) - #CIMI
#CIMI - International Mobile Subscriber Identity (IMSI)
SELINT 2
AT#CIMI
Execution command returns the international mobile subscriber identity, identified
as the IMSI number, with command echo.
AT#CIMI=?
Test command returns the OK result code.
Service Provider Name - #SPN
#SPN - Service Provider Name
SELINT 2
AT#SPN
Execution command returns the service provider string contained in the SIM field
SPN, in the format:
#SPN: <spn>
where:
<spn> - service provider string contained in the SIM field SPN, represented in the
currently selected character set (see +CSCS).
Note: if the SIM field SPN is empty, the command returns just the OK result code.
AT#SPN=?
Test command returns the OK result code.
Extended Numeric Error report - #CEER
#CEER – Extended numeric error report
SELINT 2
AT#CEER
Execution command causes the TA to return a numeric code in the format
#CEER: <code>
which should offer the user of the TA a report of the reason for
• the failure in the last unsuccessful call setup (originating or answering);
• the last call release;
• the last unsuccessful GPRS attach or unsuccessful PDP context activation;
• the last GPRS detach or PDP context deactivation.
Note: if none of the previous conditions has occurred since power up then 0 is
reported (i.e. No error, see below)
<code> values as follows
Value
Diagnostic
0
No error
1
Unassigned (unallocated) number
3
No route to destination
6
Channel unacceptable
8
Operator determined barring