Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 86 of 509
Mod. 0808 2011-07 Rev.2
+CUSD - Unstructured Supplementary Service Data
<m>:
0 - no further user action required (network initiated USSD-Notify, or no further
information needed after mobile initiated operation).
1 - further user action required (network initiated USSD-Request, or further
information needed after mobile initiated operation)
2 - USSD terminated by the network
3 - other local client has responded
4 - operation not supported
5 - network time out
Read command reports the current value of the parameter <n>
Test command reports the supported values for the parameter <n>
Advice Of Charge - +CAOC
<mode>
Set command refers to the Advice of Charge supplementary services that enable
subscriber to get information about the cost of calls; the command also includes the
possibility to enable an unsolicited event reporting of the Current Call Meter
(CCM) information.
Parameter:
<mode>
0 - query CCM value
1 - disables unsolicited CCM reporting
2 - enables unsolicited CCM reporting
Note: the unsolicited result code enabled by parameter <mode> is in the format:
+CCCM: <ccm>
where:
<ccm> - current call meter in home units, string type: three bytes of the CCM
value in hexadecimal format (e.g. “00001E” indicates decimal value 30)
Note: the unsolicited result code +CCCM
is sent when the CCM value changes, but
not more than every 10 seconds.
Read command reports the value of parameter <mode> in the format:
Test command reports the supported values for <mode> parameter.
To Next Page
Loading...
Need help?
General
