Telit Wireless Solutions LE910 - Country of Installation - +GCI

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 38 of 509
Mod. 0808 2011-07 Rev.2
Country Of Installation - +GCI
+GCI - Country Of Installation
SELINT 2
AT+GCI=<code>
Set command selects the installation country code according to
ITU-T.35 Annex A.
Parameter:
<code>
59 - it currently supports only the Italy country code
AT+GCI?
Read command reports the currently selected country code.
AT+GCI=?
Test command reports the supported country codes.
Reference
V25ter.