Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 245 of 509
Mod. 0808 2011-07 Rev.2
#CFF – Call Forwarding Flags
Set command enables/disables the presentation of the call forwarding flags URC.
Parameter:
<enable>
0 - disable the presentation of the #CFF URC (default value)
1 - enable the presentation of the #CFF URC each time the Call Forwarding
Unconditional (CFU) SS setting is changed or checked and, at startup, the
presentation of the status of the call forwarding flags, as they are currently
stored on SIM.
The URC format is:
#CFF: <status>,<fwdtonum>
where:
<status>
0 – CFU disabled
1 – CFU enabled
< fwdtonum > - number incoming calls are forwarded to
The presentation at start up of the call forwarding flags status, as they are
currently stored on SIM, is as follows:
#CFF: <status>,< fwdtonum >
where:
<status>
0 – CFU disabled
1 – CFU enabled
< fwdtonum > - number incoming calls are forwarded to
Read command reports whether the presentation of the call forwarding flags URC
is currently enabled or not, and, if the flags field is present in the SIM, the current
status of the call forwarding flags as they are currently stored on SIM, and the
number incoming calls are forwarded to. The format is:
#CFF: <enable>[,<status>,< fwdtonum >]
Test command returns the range of available values for
parameter <enable>.
GSM and UMTS Audio Codec - #CODEC
To Next Page
Loading...
Need help?
General
