Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 172 of 509
Mod. 0808 2011-07 Rev.2
+CMGL - List Messages
SELINT 2
+CMGL: <index>,<stat>,<fo>,<mr>,<ra>,<tora>,<scts>,<dt>,<st>
[<CR><LF>
+CMGL: <index>,<stat>,<fo>,<mr>,<ra>,<tora>,<scts>,<dt>,<st>
[...]]
where
<index> - message position in the storage
<stat> - message status
<fo> - first octet of the message PDU
<mr> - message reference number; 3GPP TS 23.040 TP-Message-Reference in
integer format
<ra> - recipient address, string type , represented in the currently selected
character set (see +CSCS)
<tora> - type of number <ra>
<scts> - arrival time of the message to the SC
<dt> - sending time of the message
<st> - message status as coded in the PDU
Note: If parameter is omitted the command returns the list of sms with “REC
UNREAD” status
.
Note: the order in which the messages are reported by +CMGL corresponds to their
position in the memory storage
AT+CMGL=?
Test command returns a list of supported <stat>s
Reference
3GPP TS 27.005, 3GPP TS 23.040
Read Message - +CMGR
+CMGR - Read Message
SELINT 2
AT+CMGR=
<index>
Execution command reports the message with location value <index> from
<memr> message storage (<memr>
is the message storage for read and delete SMs
as last settings of command +CPMS).
Parameter:
<index> - message index.
The output depends on the last settings of command +CMGF (message format to
be used)
(PDU Mode)
If there is a message in location <index>, the output has the following format:
+CMGR: <stat>,<alpha>,<length><CR><LF><pdu>
where

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English