Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 148 of 509
Mod. 0808 2011-07 Rev.2
PDP Context - +CGACT
+CGACT - PDP Context Activate Or Deactivate
[<state>[,<cid>
[,<cid>[,…]]]]
Execution command is used to activate or deactivate the specified PDP context(s)
Parameters:
<state> - indicates the state of PDP context activation
0 - deactivated
1 - activated
<cid> - a numeric parameter which specifies a particular PDP context definition
(see +CGDCONT command)
Note: at least three
s can be activated at the same time.
Note: if no
s are specified, the activation form of the command
activates at least the first three defined contexts. The deactivation form
deactivates all the active contexts.
Read command returns the current activation state for all the defined PDP contexts
in the format:
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state>[…]]
Test command reports information on the supported PDP context activation states
parameters in the format:
OK
AT+CGACT?
+CGACT: 1,1
To Next Page
Loading...
Need help?
General
