Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 44 of 509
Mod. 0808 2011-07 Rev.2
Fixed DTE Interface Rate - +IPR
+IPR - Fixed DTE Interface Rate
Set command specifies the DTE speed at which the device accepts commands
during command mode operations; it may be used to fix the DTE-DCE interface
speed.
Parameter:
<rate>
300
1200
2400
4800
9600
19200
38400
57600
115200 (default value)
230400
460800
921600
Read command returns the current value of +IPR parameter.
Test command returns the list of fixed-only <rate> values in the format:
+IPR: (list of fixed-only <rate> values)
To Next Page
Loading...
Need help?
General
