Telit Wireless Solutions LE910 - Manufacturer Identification - #CGMI; Model Identification - #CGMM; Network Selection Menu Availability - +PACSP; Revision Identification - #CGMR

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 190 of 509
Mod. 0808 2011-07 Rev.2
DLCI_2 connected to AT parser
Telit Mobile (USB3) connected to AT parser
Telit Mobile (USB4) connected to AT parser
AT#DLINK?
Read command reports <status> and <urc_mode> parameter
values in the following format:
#DLINK: <status>,<urc_mode>
AT#DLINK=?
Test command returns the list of supported values.
Network Selection Menu Availability - +PACSP
+PACSP - Network Selection Menu Availability
SELINT 2
AT+PACSP?
Read command returns the current value of the <mode> parameter in the format:
+PACSP<mode>
where:
<mode> - PLMN mode bit (in CSP file on the SIM)
0 - restriction of menu option for manual PLMN selection.
1 - no restriction of menu option for Manual PLMN selection.
AT+PACSP=?
Test command returns the OK result code.
Manufacturer Identification - #CGMI
#CGMI - Manufacturer Identification
SELINT 2
AT#CGMI
Execution command returns the device manufacturer identification code with
command echo.
AT#CGMI=?
Test command returns the OK result code.
Model Identification - #CGMM
#CGMM - Model Identification
SELINT 2
AT#CGMM
Execution command returns the device model identification code with command
echo.
AT#CGMM=?
Test command returns the OK result code.
Revision Identification - #CGMR
#CGMR - Revision Identification
SELINT 2
AT#CGMR
Execution command returns device software revision number with command echo.
AT#CGMR=?
Test command returns the OK result code.