Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 67 of 509
Mod. 0808 2011-07 Rev.2
+CRC - Cellular Result Codes
instead of the normal RING.
where
<type> - call type:
ASYNC - asynchronous transparent data
SYNC - synchronous transparent data
REL ASYNC - asynchronous non-transparent data
REL SYNC - synchronous non-transparent data
VOICE - normal voice (TS 11)
Read command returns current value of the parameter <mode>.
Test command returns supported values of the parameter <mode>.
Voice Hung Up Control - +CVHU
+CVHU - Voice Hang Up Control
[<mode>]
Set command selects whether ATH or "drop DTR" shall cause a voice connection
to be disconnected or not.
Parameter:
<mode>
0 - "Drop DTR" ignored but OK result code given. ATH disconnects.
1 - "Drop DTR" and ATH ignored but OK result code given.
2 - "Drop DTR" behavior according to &D setting. ATH disconnects
Read command reports the current value of the <mode> parameter, in the format:
Test command reports the range of supported values for parameter <mode>
Select type of address - +CSTA
+CSTA – Select Type of Address
[<type>]
Set command selects the type of number for further dialing commands (D)
according to GSM/UMTS specifications.
Parameter:
<type>: type of address octet in integer format (refer TS 24.008,
subclause 10.5.4.7); default 145 when dialing string includes international access
code character "+", otherwise 129
Read command returns the current value of <type> in the format:
To Next Page
Loading...
Need help?
General
