To Next Page

To Previous Page

Telit LE910 V2 Series AT Commands

80446ST10707A Rev. 0– 2015-11-03

Mod. 0808 2011-07 Rev.2

Escape Sequence Guard Time - #E2ESC

#E2ESC - Escape Sequence Guard Time

SELINT 2

AT#E2ESC=

[<gt>]

Set command sets a guard time in seconds for the escape sequence in GPRS to be

considered a valid one (and return to on-line command mode).

Parameter:

<gt>

0 - guard time defined by command S12 (factory default)

1..10 - guard time in seconds

Note: if the Escape Sequence Guard Time is set to a value different from zero, it

overrides the one set with S12.

AT#E2ESC?

Read command returns current value of the escape sequence guard time, in the

format:

#E2ESC: <gt>

AT#E2ESC=?

Test command returns the range of supported values for parameter <gt>.