Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 418 of 509
Mod. 0808 2011-07 Rev.2
4.1.6.11. HTTP Client AT Commands
Configure HTTP Parameters - #HTTPCFG
#HTTPCFG – configure HTTP parameters
SELINT 2
AT#HTTPCFG=<prof_id>[,<s
erver_address>[,<server_p
ort>[,<auth_type>[,<userna
me>[,<password>[,<ssl_ena
bled>[,<timeout>
[,<cid>[,<pkt_size>][,
<UNUSED_1>[,
<UNUSED_2>]]]]]]]]]]
This command sets the parameters needed to the HTTP connection
Parameters:
<prof_id>
- Numeric parameter indicating the profile identifier.
Range: 0-2
<server_address> -
String parameter indicating the IP address of
the HTTP server.
This parameter can be either:
- any valid IP address in the format: “xxx.xxx.xxx.xxx”
- any host name to be solved with a DNS query
Default: “” for first and second profile; "m2mlocate.telit.com" for
third profile.
<server_port> -
Numeric parameter indicating the TCP remote
port of the HTTP server to connect to.
Default: 80 for first and second profile; 9978 for third profile. Range
1...65535.
<auth_type> -
Numeric parameter indicating the HTTP
authentication type.
0 – no authentication (default)
1 – basic authentication
<username>
- String parameter indicating authentication user
identification string for HTTP.
<password>
- String parameter indicating authentication password
for HTTP.
<ssl_enabled> -
Numeric parameter indicating if the SSL
encryption is enabled.
0 – SSL encryption disabled (default)
1 – SSL encryption enabled
<timeout>
: Numeric parameter indicating the time interval in
seconds to wait for receiving data from HTTP server. Range: (1-
65535). Default: 120.

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English