Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 419 of 509
Mod. 0808 2011-07 Rev.2
- Numeric parameter indicating the PDP Context Identifier.
Range: (0-5). Default: 3
- send(#HTTPSND) or recv(#HTTPRCV) size
for data sending or receiving.
0 – select automatically default value(300).
1..1500 – send or recv size in bytes.
Note: an ERROR is issued if <UNUSED_1> and <UNUSED_2>
parameters are set with a value different from 0.
Note: a special form of the Set command,
,
causes the values for profile number
to reset to default
values.
Note: only one profile can use the SSL encryption.
Note: the SSL encryption can be enabled only if <Enable>
parameter of #SSLEN is set to 0 and <FTPSEn> parameter of
#FTPCFG is set to 0.
Note: if it’s needed to configure security parameters, it is possible
to use #SSLSECCFG/#SSLSECDATA commands as usual for
#SSLD
Note: values are automatically saved in NVM.
Read command returns the current settings for each defined
profile in the format:
#HTTPCFG:
<prof_id>,<s
erver_address>,<serv
er_port>,<auth_type>,<
usern
ame>,<password>,<ssl_enabled>,<timeout>,<cid>,<pkt_size>,0,
0<CR><LF>[<CR><LF>#HTTPCFG:
<prof_id>,<s
erver_address>,<serv
er_port>,<auth_type>,<
usern
ame>,
<pass
word
>,<ssl
_ena
bled
>,<time
out
>,<ci
d>,<p
kt_siz
e>,0,
0]<CR><LF>[…]]
Test command returns the supported range of parameters
<prof_i
d>, <se
rver_
port
>, <auth
_type
>, <ssl_e
nable
d>,
<timeout>,<cid>
and
and the maximum length of
<server_address>, <username>
and
parameters in
To Next Page
Loading...
Need help?
General
