Telit Wireless Solutions LE910 - TCP at Run Authentication Parameters List - #TCPATRUNAUTH

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 300 of 509
Mod. 0808 2011-07 Rev.2
TCP AT Run Authentication Parameters List - #TCPATRUNAUTH
#TCPATRUNAUTH – TCP AT Run Authentication Parameters List
SELINT 2
AT#
TCPATRUNAUTH
=
<action>,
<userid>,
<passw>
Execution command controls the authentication parameters for the
TCPATRUN connection.
Parameters:
<action> - command action
0 - remove selected chain
1 - add an ACCEPT chain
2 - remove all chains (DROP everything); < userid > and < passw >
has no meaning in this case.
< userid > - user to be added into the ACCEPT chain; string type,
maximum length 50
< passw > - password of the user on the < userid >; string type,
maximum length 50
Command returns OK result code if successful.
Note1: A maximum of 3 entry (password and userid) can be present at
same time in the List.
Note2: the Authentication Parameters List is saved in NVM.
AT#TCPATRUNAUTH?
Read command reports the list of all ACCEPT chain rules registered in
the Authentication settings in the format:
#TCPATRUNAUTH: <user_id>,<passw>
#TCPATRUNAUTH: <user_id>,<passw>
….
OK
AT#TCPATRUNAUTH=?
Test command returns the allowed values for parameter <action>.