Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 256 of 509
Mod. 0808 2011-07 Rev.2
#SIMDET - SIM Detection Mode
Read command returns the currently selected Sim Detection Mode in the format:
#SIMDET: <mode>,<simin>
where:
<mode> - SIM Detection mode, as before
<simin> - SIMIN pin real status
0 - SIM not inserted
1 - SIM inserted
Test command reports the supported range of values for parameter <mode>
GSM Context Definition - #GSMCONT
#GSMCONT - GSM Context Definition
<CSD_num>]
Set command specifies context parameter values for the only GSM context,
identified by the (local) context identification parameter 0.
Parameters:
<cid> - context Identifier; numeric parameter which specifies the only GSM
context
0
<P_type> - protocol type; a string parameter which specifies the type of protocol
"IP" - Internet Protocol
<CSD_num> - phone number of the internet service provider
Note: issuing #GSMCONT=0 causes the values for context number 0 to become
undefined.
Read command returns the current settings for the GSM context, if defined, in the
format:
+GSMCONT: <cid>,<P_type>,<CSD_num>
Test command returns the supported range of values for all the parameters.
To Next Page
Loading...
Need help?
General
