Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 302 of 509
Mod. 0808 2011-07 Rev.2
Closing TCP Run AT Socket - #TCPATRUNCLOSE
#TCPATRUNCLOSE – Closes TCP Run AT Socket
Closes the socket used by TCP ATRUN service.
Note: TCP ATRUN status is still enabled after this command, so the
service re-starts automatically.
TCP AT Run Command Sequence - #TCPATCMDSEQ
#TCPATCMDSEQ – For TCP Run AT Service, allows the user to give AT commands
in sequence
<mod>
Set command enable/disable, for TCP Run AT service, a feature that allows
giving more than one AT command without waiting for responses.
It does not work with commands that uses the prompt '>' to receive the
message body text (e.g. “at+cmgs”)
Parameter:
< mod >
0: Service Disabled (default)
Read command returns the current settings of parameters in the format:
Test command returns the supported values for the TCPATCMDSEQ
parameters
TCP Run AT service to a serial port - #TCPATCONSER
#TCPATCONSER – Connects the TCP Run AT service to a serial port
<port>,<rate>
Set command sets the TCP Run AT in transparent mode, in order to have
direct access to the hardware port specified. Data will be transferred
directly, without being elaborated, between the T
CP Run AT service and the
hardware port specified.
If the CMUX protocol is running the command will return ERROR.
Parameter:
< port >
0 – USIF0
1 – USIF1
2 – USB0
3 – USB1
To Next Page
Loading...
Need help?
General
