Telit Wireless Solutions LE910 - SIM Tookit Terminal Attach - #STTA; Configure SIM Toolkit Application Parameters - #STACFG; Available

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 442 of 509
Mod. 0808 2011-07 Rev.2
#STSR - SIM Tookit Send Response
SELINT 2
Note:
Use of icons is not supported. All icon related actions will respond with no icon
available.
AT#STSR?
The read command can be used to request the currently ongoing proactive
command and the SAT state in the format
#STSRI: <state>,<cmdType>
where:
<state> - SAT interface state (see #STIA)
<cmdType> - ongoing proactive command
An error message will be returned if there is no pending command.
AT#STSR=?
Test command returns the range for the parameters <state> and <cmdType>.
SIM Tookit terminal Attach - #STTA
#STTA – SIM Toolkit Terminal Attach
SELINT 2
AT#STTA=<state>
This command attaches/detaches the SIM Toolkit application to the AT
instance reserved for this use (see #STACFG).
Parameters:
<state>: attached state
0 – SIM Toolkit detaches
1 – SIM Toolkit attaches
If SIM Toolkit application has been already attached/detached the
command does nothing and returns OK.
AT#STTA?
Read command reports the current <state> in the format:
#STTA: <state>
AT#STTA=?
Test command reports the supported range of values for parameter
<state>
Note
The AT instance reserved for the SIM Toolkit application is setted by the
command #STACFG (default is #3).
Configure SIM Toolkit Application parameters - #STACFG