EasyManuals Logo

Telit Wireless Solutions LE910 User Manual

Telit Wireless Solutions LE910
509 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 131 of 509
Mod. 0808 2011-07 Rev.2
+CGREG - GPRS Network Registration Status
SELINT 2
where:
<stat> - registration status (see above for values)
<lac> - location area code in hexadecimal format (e.g. "00C3" equals 195 in
decimal)
<ci> - cell ID in hexadecimal format.
<AcT>: access technology of the registered network:
0 GSM
2 UTRAN
3 GSM w/EGPRS
4 UTRAN w/HSDPA
5 UTRAN w/HSUPA
6 UTRAN w/HSDPA and HSUPA
<rac>: string type; one byte routing area code in hexadecimal format
Note: <lac>, <Ci>, <AcT> and <rac> are reported only if <mode>=2 and the
mobile is registered on some network cell.
AT+CGREG?
Read command returns the status of result code presentation mode <n> and the
integer <stat> which shows whether the network has currently indicated the
registration of the terminal in the format:
+CGREG: <n>,<stat>[,<lac>,<ci>[,<AcT>,<rac>]]
Note: <lac>, <Ci>, <AcT> and <rac> are reported only if <mode>=2 and the
mobile is registered on some network cell.
AT+CGREG=?
Test command returns supported values for parameter <n>
Reference
3GPP TS 27.007
Define PDP Context - +CGDCONT
+CGDCONT - Define PDP Context
SELINT 2
AT+CGDCONT=
[<cid>
[,<PDP_type>
[,<APN>
[,<PDP_addr>
[,<d_comp>
[,<h_comp>
[,
<IPv4AddrAlloc>[,<
emergency_indicatio
n>[,<P-
CSCF_discovery>[,<I
Set command specifies PDP context parameter values for a PDP context
identified by the (local) context identification parameter,
<cid>
Parameters:
<cid>
- (PDP Context Identifier) numeric parameter which specifies a
particular PDP context definition.
1..
max
- where the value of
max
is returned by the Test command
<PDP_type>
- (Packet Data Protocol type) a string parameter which
specifies the type of packet data protocol
"IP" - Internet Protocol
"IPV6" - Internet Protocol version 6

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910 and is the answer not in the manual?

Telit Wireless Solutions LE910 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910
CategoryControl Unit
LanguageEnglish

Related product manuals