Telit Wireless Solutions LE910 - Extended Result Codes - X; Identification Information

To Next Page

To Previous Page

Telit LE910 V2 Series AT Commands

80446ST10707A Rev. 0– 2015-11-03

Mod. 0808 2011-07 Rev.2

Extended Result Codes - X

X - Extended Result Codes

SELINT 2

ATX[<n>]

Set command selects the result code messages subset used by the modem to inform

the DTE of the result of the commands.

Parameter:

<n> - (factory default is 1)

0 - on entering dial-mode CONNECT result code is given; OK, CONNECT,

RING, NO CARRIER, ERROR, NO ANSWER result codes are enabled .

Dial tone and busy detection (NO DIALTONE and BUSY result codes) are

disabled.

1..4 - on entering dial-mode CONNECT <text> result code is given; all the other

result codes are enabled.

Note: If parameter is omitted, the command has the same behaviour of ATX0

Reference

V25ter

Identification Information - I

I - Identification Information

SELINT 2

ATI[<n>]

Execution command returns one or more lines of information text followed by a

result code.

Parameter:

<n>

0 - numerical identifier

1 - module checksum

2 - checksum check result

3 - manufacturer

4 - product name

5 - DOB version

Note: if parameter is omitted, the command has the same behaviour of ATI0

Reference

V25ter

Telit Wireless Solutions LE910 - Extended Result Codes - X; Identification Information - I