Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 89 of 509
Mod. 0808 2011-07 Rev.2
Closed User Group - +CCUG
+CCUG - Closed User Group Supplementary Service Control
[<n>[,<index>
[,<info>]]]
Set command allows control of the Closed User Group supplementary service
[GSM 02.85].
Parameters:
<n>
0 - disable CUG temporary mode (factory default).
1 - enable CUG temporary mode: it enables to control the CUG information on the
air interface as a default adjustment for all following outgoing calls.
<index>
0..9 - CUG index
10 - no index (preferential CUG taken from subscriber data) (default)
<info>
0 - no information (default)
1 - suppress Outgoing Access (OA)
2 - suppress preferential CUG
3 - suppress OA and preferential CUG
Read command reports the current value of the parameters
Test command returns the OK result code
Preferred Operator List - +CPOL
+CPOL - Preferred Operator List
[<index>][,<format>
[,<oper>[,<GSM_AcT>,
<GSM_Compact_AcT>,
<UTRAN_AcT,<EUTRAN_
AcT>]]]
Execution command writes an entry in the SIM list of preferred operators.
Parameters:
<index> - integer type; the order number of operator in the SIM preferred
operator list
1..n
<format>
0 – long format alphanumeric <oper>
2 - numeric <oper>
<oper> - string type
<GSM_AcT> - GSM access technology
0 – access technology not selected
1 – access technology selected
<GSM_Compact_AcT> - GSM compact access technology
0 – access technology not selected
1 – access technology selected
<UTRAN_AcT> - UTRAN acess technology
0 – access technology not selected
1 – access technology selected
To Next Page
Loading...
Need help?
General
