Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 267 of 509
Mod. 0808 2011-07 Rev.2
Enable RX Diversity and set DARP - #RXDIV
#RXDIV – enable RX Diversity and set DARP
DARP_mode>]
This command enables/disables the RX Diversity and sets the DARP.
Parameters:
<DIV_enable>
RX Diversity
0 - disable the RX Diversity
1 - enable RX Diversity (default value)
<DARP_mode>
DARP mode
0 – DARP not supported
1 – DARP phase 1
2 – DARP phase 2 traffic only
3 – DARP always on (default value)
Note: the values set by command are directly stored in NVM and don’t
depend on the specific CMUX instance. They are available at next power
on.
Note: if <DIV_enable> is set to 0, then <DARP_mode> is automatically
set to 1 regardless the set value
Read command reports the currently selected <DIV_enable> and
<DARP_mode> parameters in the format:
#RXDIV: <DIV_enable>,<DARP_mode>
Test command reports the supported range of values for parameters
<DIV_enable> and <DARP_mode>
Set Encryption algorithm - #ENCALG
#ENCALG – Set Encryption Algorithm
<encGPRS>]
This command enables or disables the GSM and/or GPRS encryption
algorithms supported by the module.
Parameters:
<encGSM>:
0 – no GSM encryption algorithm
1..7 - sum of integers each representing a specific GSM encryption
algorithm: