Telit Wireless Solutions LE910 - Page 268

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 268 of 509
Mod. 0808 2011-07 Rev.2
2 – A5/2
4 – A5/3
255 - reset the default values
<encGPRS>:
0 – no GPRS encryption algorithm
1..7 - sum of integers each representing a specific GPRS encryption
algorithm:
1 – GEA1
2 – GEA2
4 – GEA3
255 - reset the default values
Note: the values are stored in NVM and available on following reboot.
Note: For possible <encGSM> and <encGPRS> encryptions see test
command response.
Note: If no parameter is issued, the set command returns ERROR.
AT#ENCALG?
Read command reports the currently selected <encGSM> and
<encGPRS>, and the last used <useGSM> and <useGPRS> in the
format:
#ENCALG: <encGSM>,<encGPRS>,<usedGSM>,<usedGPRS>
Parameters:
<usedGSM>:
0 – no GSM encryption algorithm
1 – A5/1
2 – A5/2
4 – A5/3
255 – not available
<usedGPRS>:
0 – no GPRS encryption algorithm
1 – GEA1
2 – GEA2
4 – GEA3
255 – not available
AT#ENCALG=?
Test command reports the supported range of values for parameters in the
format:
< encGSM > and <encGPRS>.
Example
AT#ENCALG?
#ENCALG: 5,2,1,1
OK