Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 250 of 509
Mod. 0808 2011-07 Rev.2
#CCLKMODE – Clock Mode
SELINT 2
Enhanced Network Selection - #ENS
#ENS - Enhanced Network Selection
SELINT 2
AT#ENS=[<mode>]
Set command is used to activate the ENS functionality.
Parameter:
<mode>
0 - disable ENS functionality (default for all products except LE910-NA)
1 - enable ENS functionality (default for LE910-NA products); if AT#ENS=1 has
been issued, the following values will be automatically set:

at every next power-up
a
Band GSM 850 and PCS enabled (AT#BND=3)
b SIM Application Toolkit enabled on user interface 0 if not previously
enabled on a different user interface (AT#STIA=2)

just at first next power-up
a
Automatic Band Selection enabled (AT#AUTOBND=2) only if the
previous setting was equal to AT#AUTOBND=0
Note: the new setting will be available just at first next power-up.
Note: If ‘Four Band’ Automatic Band Selection has been activated
(AT#AUTOBND=2), at power-up the value returned by AT#BND? could be
different from 3 when ENS functionality is enabled.
AT#ENS?
Read command reports whether the ENS functionality is currently enabled or not,
in the format:
#ENS: <mode>
where:
<mode> as above
AT#ENS=?
Test command reports the available range of values for parameter <mode>.
Reference
Cingular Wireless LLC Requirement
Band Selection - #BND
#BND - Select Band
SELINT 2
AT#BND=
<band> [,<UMTS
band>[,<LTE
band>]]
Set command selects the current GSM,UMTS and LTE bands.
Parameter
<band>:
0 - GSM 900MHz + DCS 1800MHz (default value)

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English