Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 251 of 509
Mod. 0808 2011-07 Rev.2
1 - GSM 900MHz + PCS 1900MHz; this value is not available if the ENS
functionality has been activated (see #ENS)
2 - GSM 850MHz + DCS 1800MHz (available only on quadri-band modules); this
value is not available if the ENS functionality has been activated (see #ENS)
3 - GSM 850MHz + PCS 1900MHz (available only on quadri-band modules)
<UMTS band>:
0 - 1900 / 2100MHz(FDD I)
1 - 1900MHz(FDD II) (default value depending on product)
2 - 850MHz(FDD V)
3 - 2100MHz(FDD I) + 1900MHz(FDD II) + 850MHz(FDD V)
4 - 1900MHz(FDD II) + 850MHz(FDD V)
5 - 900MHz(FDD VIII) (default value, depending on the product)
6 - 2100MHz(FDD I) + 900MHz(FDD VIII)
7 – 1700/ 2100MHz(FDD IV, AWS)
<LTE band> values in the range 1 – 4294967295 as a sum of:
1 - B1
2 - B2
4 - B3
8 - B4
…
i - B(2exp(i-1))
…
2147483648 - B32
Note: This setting is maintained even after power off.
Note: if the automatic band selection is enabled (AT#AUTOBND=2) then you can
issue AT#BND=<band>,<UMTS band>,<LTE band> but it will have no
functional effect; nevertheless every following read command AT#BND? will
report that setting.
Note: not all products support all the values of parameter <band>: please refer to
test command to find the supported range of values.
Note: not all products support all the values of parameter <UMTS band>: please
refer to test command to find the supported range of values.
Note: not all products support all the values of parameter <LTE band>: please
refer to test command to find the supported range of values (maximum value is the
sum representation of supported bands).
Note: for 4G only product use fixed unused value 0 for <band> and <UMTS
To Next Page
Loading...
Need help?
General
