Telit Wireless Solutions LE910 - User Defined Tone Reset - #UDTRST Command; User Defined Tone SAVE - #UDTSAV Command

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 455 of 509
Mod. 0808 2011-07 Rev.2
User Defined Tone SAVE - #UDTSAV command
#UDTSAV – User Defined Tone SAVe
SELINT 2
AT#UDTSAV
Execution command saves the actual values of frequency and amplitude parameters
that have been set with the command #UDTSET
AT#UDTSAV =?
Test command returns the OK result code.
Example
AT#UDTSAV
OK
Current tones are saved in NVM
User Defined Tone Reset - #UDTRST command
#UDTRST – User Defined Tone ReSeT
SELINT 2
AT#UDTRST
Execution command resets to the default set the actual values of frequency and
amplitude parameters that can be set with the command #UDTSET.
AT#UDTRST =?
Test command returns the OK result code.
Example
AT#UDRST
OK
The default value tones are restored in NVM