EasyManuals Logo

Telit Wireless Solutions LE910 User Manual

Telit Wireless Solutions LE910
509 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 73 of 509
Mod. 0808 2011-07 Rev.2
Select Wireless Network - +WS46
+WS46 - PCCA STD-101 Select Wireless Network
SELINT 2
AT+WS46=[<n>]
Set command selects the cellular network (Wireless Data Service, WDS) to
operate with the TA (WDS-Side Stack Selection).
Parameter:
<n> - integer type, it is the WDS-Side Stack to be used by the TA.
12 - GSM Digital Cellular Systems (GERAN only)
22 UTRAN only
25 3GPP Systems (GERAN and UTRAN and E-UTRAN) (factory default)
28 E-UTRAN only
29 GERAN and UTRAN
30 GERAN and E-UTRAN
31 UTRAN and E-UTRAN
NOTE: <n> parameter setting is stored in NVM and available at next reboot.
NOTE: 4G only products support <n> parameter value 28 only.
NOTE: 4G/3G only products support <n> parameter values 22, 28 and 31 only. 31
is factory default
NOTE: 4G/2G only products support <n> parameter values 12, 28 and 30 only. 30
is factory default
AT+WS46?
Read command reports the currently selected cellular network, in the format:
+ WS46: <n>
AT+WS46=?
Test command reports the range for the parameter <n>.
Reference
3GPP TS 27.007
Facility Lock/Unlock - +CLCK
+CLCK - Facility Lock/Unlock
SELINT 2
AT+CLCK=
<fac>,<mode>
[,<passwd>
[,<class>]]
Execution command is used to lock or unlock a ME on a network facility.
Parameters:
<fac> - facility
"PS" - PH-SIM (lock Phone to SIM card) MT asks password when other than
current SIM card inserted; MT may remember certain amount of previously
used cards thus not requiring password when they are inserted
"PF" - lock Phone to the very First inserted SIM card (MT asks password when
other than the first SIM card is inserted)
"SC" - SIM (PIN request) (device asks SIM password at power-up and when this
lock command issued)
"AO"- BAOC (Barr All Outgoing Calls)
"OI" - BOIC (Barr Outgoing International Calls)
"OX" - BOIC-exHC (Barr Outgoing International Calls except to Home Country)
"AI" - BAIC (Barr All Incoming Calls)
"IR" - BIC-Roam (Barr Incoming Calls when Roaming outside the home country)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910 and is the answer not in the manual?

Telit Wireless Solutions LE910 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910
CategoryControl Unit
LanguageEnglish

Related product manuals