Telit Wireless Solutions LE910 - Page 72

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 72 of 509
Mod. 0808 2011-07 Rev.2
+COPS - Operator Selection
SELINT 2
+COPS: [list of supported (<stat> ,<oper (in <format>=0)>,,
<oper (in <format>=2)>,< AcT>)s][,,(list of supported <mode>s),
(list of supported<format>s)]
where
<stat> - operator availability
0 - unknown
1 - available
2 - current
3 - forbidden
<AcT> access technology selected:
0 GSM
2 UTRAN
7 E-UTRAN
Note: since with this command a network scan is done, this command may require
some seconds before the output is given.
Reference
3GPP TS 27.007